• <tt id="yu24o"><input id="yu24o"></input></tt> <tt id="yu24o"></tt>
  • <samp id="yu24o"><label id="yu24o"></label></samp>
  • <blockquote id="yu24o"><nav id="yu24o"></nav></blockquote>
  • <optgroup id="yu24o"></optgroup>
  • <input id="yu24o"><samp id="yu24o"></samp></input>
  • 咨詢熱線
    當前位置: 首頁 > 新聞中心 > 行業新聞 >

    電動卷簾門邊角脫落的原因與解決方法

    發布人:http://www.al-watany.com    發布時間:2021-09-24 13:58:11

    使用過電動卷簾門的業主,應該都會有這樣的疑問,就是它使用一段時間之后,會出現后門的比較脫落,這是什么原因呢?今天小編就來具體分析一下原因與解決方法。
    Owners who have used the electric rolling shutter door should have such a question that the back door will fall off after it is used for a period of time. What is the reason? Today, Xiaobian will specifically analyze the causes and solutions.
    1、清潔簾布時,采用軟的棉布擦拭,用硬幣很容易劃傷表面,污跡太重時,可以使用清洗劑、牙膏、專用清洗劑等。去污后用清水擦拭,然后擦干,正確的清潔方法能夠使快速電動卷簾門始終保持亮麗如新。
    1. When cleaning the cord fabric, wipe it with soft cotton cloth. It is easy to scratch the surface with coins. When the stain is too heavy, you can use cleaning agent, toothpaste, special cleaning agent, etc. After decontamination, wipe it with clean water and then dry it. The correct cleaning method can always keep the fast electric rolling shutter door as bright as new.
    2、注意棱角處不要過多的擦磨,否則會造成棱角表皮層脫落。
    2. Pay attention not to rub the edges and corners too much, otherwise it will cause the edge epidermis to fall off.
    3、使用前應由工作人員有用調試好后,方可對門體進行運行操作。
    3. Before use, the door body can be operated only after being debugged by the staff.
    4、電動卷簾門體在運行的時候,門體下方禁止有小孩或物品,以免運行過程中傷到小孩或物品。
    4. When the electric rolling shutter door body is running, children or articles are prohibited under the door body to avoid hurting children or articles during operation.
    5、在運行過程中觀察是否有異常響動,如有異常噪音,需通知人士進行維護保養。
    5. Observe whether there is abnormal noise during operation. If there is abnormal noise, notify people for maintenance.
    6、當電動機的熱保護連續發生動作時,應查明故障來自電動機還是超負荷或保護裝置整定值太低,消 除故障后,方可投入運行。
    6. When the thermal protection of the motor acts continuously, find out whether the fault is from the motor or overload or the setting value of the protection device is too low. After the fault is eliminated, it can be put into operation.
    7、應電動機在運行過程中良好的潤滑。一般的電動機運行5000小時左右,即應補充或更換潤滑脂,運行中發現軸承過熱或潤滑變質時,液壓及時換潤滑脂。更換潤滑脂時,應清 除舊的潤滑油,并有汽油洗凈軸承及軸承蓋的油槽,然后將ZL-3鋰基脂填充軸承內外圈之間的空腔的1/2(對2極)及2/3(對4、6、8極)。
    7. The motor shall be well lubricated during operation. Generally, when the motor runs for about 5000 hours, the lubricating grease shall be supplemented or replaced. When the bearing is overheated or the lubrication is deteriorated during operation, the hydraulic pressure shall change the lubricating grease in time. When replacing the grease, remove the old lubricating oil and clean the oil groove of the bearing and bearing cover with gasoline, and then fill 1 / 2 (for 2 poles) and 2 / 3 (for 4, 6 and 8 poles) of the cavity between the inner and outer rings of the bearing with zl-3 lithium grease.
    8、因門體始終處于扭簧拉力狀態,如需修理維護等工作,需聯系人士操作。
    8. Since the door body is always in the tension state of torsion spring, if repair and maintenance are required, contact people for operation.
    以上就是電動卷簾門邊角脫落的原因與解決方法介紹,希望對你有幫助。
    The above is the reason and solution of the corner falling off of the electric rolling shutter door. I hope it will be helpful to you.
    上一篇:如何選擇適合自己需求的車庫門?
    下一篇:濟南電動卷簾門的開關使用規范有哪些?
    產品中心
    聯系我們